| ADSL Compliance |
• Compliant with ADSL standards:
- Full-rate ANSI T1.413 Issue 2, G.hs (6.944.1) and ITU G.dmt (G.992.1)
standards
- Splitterless G.lite (G.992.2) specification
- Annex A
• DMT modulation and demodulation
• Full-rate adaptive modem
- Maximum downstream rate of 8 Mbps
- Maximum upstream rate of 1 Mbps
• Supports splitterless ADSL implementation
• Supports DSLAM notification on power loss (Dying gasp)
• Interoperable with all major DSLAM manufacturers |
| ATM Protocols |
• WAN mode support: PPP over ATM (RFC 2364) and PPP over Ethernet (RFC 2516)
• LAN mode support: bridged/routed IP over ATM (RFC 1483) and Classical IP over ATM (RFC 1577)
• ATM Forum UNI 3.1/4.0 PVC
• Up to eight virtual circuits
• ATM segmentation and re-assembly
• ATM AAL5 (adaption layer type 5)
• OAM F4/F5 |
| Bridge Mode |
• Ethernet to ADSL self learning - Transparent Bridging (IEEE 802.1D)
• Supports up to 128 MAC learning addresses |
| Router Mode |
• Static routing
• DNS Proxy
• Port Forwarding
• DHCP (Dynamic Host Configuration Protocol) server and client
• NAT (Network Address Translation)
• NAPT (Network Address and Port Translation)
• Simultaneous USB and Ethernet operation |
| Security |
• User authentication for PPP
• PAP (Password Authentication Protocol)
• CHAP (Challenge Authentication Protocol)
• Password protected system management |
| Ethernet Interface |
• IEEE 802.3 compliant
• 10/100 BaseT - RJ45 |
| USB Interface |
• Compliant with USB Specification, Revision 1.1
• Full-speed USB (12 Mbps) |
| Web-based |
• HTTP Graphical User Interface
• Password protected access
• Firmware upgrades
• WAN and LAN side connection statistics
• Configuration of static routes and routing table
• Configuration of NAT/NAPT
• Selection of bridge or router mode
• PPP user ID and password
• Configuration of virtual circuits |
| Size |
•14.6cm x 11.2cm x 2.8cm (5.7 inches x 4.4 inches x 1.1 inches) |
| Regulatory Approval |
• CE, UL, C-UL, FCC Part 15B, FCC Part 68, CS-03 |
